A beautiful, easy to use dollhouse miniature silicone mold especially made for UV Resin! Make dollhouse miniature soft drink cap and straw.
You can make 2 types of soft drink caps - Dome Shape Cap and Flat Cap
There are 3 sizes for each type in this mold.
The smallest size is meant for 1/12 scale dollhouse miniatures.
♥♥♥♥♥
MEASUREMENTS:
Mold measures approximately 7cm x 5cm.
Small Dome Cap measures approximately 7mm wide x 3.5mm tall.
Medium Dome Cap measures approximately 14mm wide x 7mm tall.
Large Dome Cap measures approximately 16mm wide x 9mm tall.
Small Flat Cap measures approximately 9mm wide x 1.5mm tall.
Medium Flat Cap measures approximately 17mm wide x 2mm tall.
Large Flat Cap measures approximately 19mm wide x 2mm tall.
Straws-
Small: 1mm wide x 34mm tall
Large: 1.5mm wide x 39mm tall
♥♥♥♥♥
TIP:
You can use a nail file, or sand paper to file down the rough edges after the UV resin has been cured under the UV lamp.
♥♥♥♥♥
This listing is for the MOLD only. The actual cup as shown is NOT included in the purchase.
This is a supply intended for adults. Not suitable for young children.
♥♥♥♥♥
For soft drink cup mold:
http://peiliminiatures.com/item_675/Dollhouse-Miniature-Soft-Drink-Cup-Silicone-Mold.htm
♥♥♥♥♥
Please read shipping policies before purchasing. If you have further questions, please feel free to contact me.
All images and content © Pei Li Miniatures. All rights reserved.